Electrical motors essay, including: Crane motors, Lift motors, Double-cage induction motors, etc.

INTRODUCTION Standard general-purpose beat backs generate several(prenominal) advantages of importance to the user of electric car motor drives. These go up due to the high degree of normalisation in legal injury of rating, duty, dimensions, electrical and thermal characteristics, and construction and in any sheath because they atomic number 18 manufactured in enlarged numbers. The main advantages argon their relatively low cost, they argon slowly to replace immediately with another motor without any modifications, they ar easy to repair, and argon readily available. However, there are supererogatory requirements for particular applications special motors are inevitable. In some cases standard lay sizes can be used with special shafts, finishes or acclivity arrangements. In others, all special performance characteristics or property constraints demand a completely new design. CRANE MOTORS The marches stretch motors can ordinarily be applied to motors, which operate out the three primary crane functions: Load lifting and displace (hoist motors); Motion along the factory; Motion across the factory. more often than not one motor is employed for each of these functions, except in the case of place or grapple cranes where two motors construct to ca-caher to run the opening and closing motion of the position and grapple and the hoisting motion. Because of the very(prenominal) hold up requirements (variable torque loads, acceleration, stopping and reversal) crane motors are all d.c. or a.c.

wound-motor induction motors, although cage motors are used for infinitesima l hoists and cranes where precise control is! not necessary. heavy-duty steelworks cranes which have wide load variations are fit out with d.c. series motors supplied from a constant voltage d.c. power supply. The fundamental urge on control is inherent in the motor speed regulation. Series-connected tapped resistance banks are switched to provide current limiting on starting and low-speed operation. In cases where charming speed control is essential, Ward-Leonard or thyristor controlled d.c. motor drives are usually the first choice. Wound-rotor a.c. If you want to get a full essay, army it on our website: BestEssayCheap.com

If you want to get a full essay, visit our page: cheap essay